Laerdal SimView User Manual download pdf (Page 42)

Figure 89

The automatic clean-up for saved simulation is enabled on the server settings by entering the number of days

that simulation have to be older than in order to be deleted (1), and then click in the check to enable the

feature checkbox and save changes (2), you will get at warning to alert you about the automatic deletion of

files. (See Figure 89)

Note! Sessions marked as protected will not be deleted.

System notification 7.4

Figure 90

If you get this message you will have to click it and under server setting you will see what caused the

warning.

Note! Only the admin user is able to see the information in the Server settings

Figure 91

Solve the issue indicated in the System notification area. This can be system driver upgrade, an Upgrade

notification or as shown here a hard disk clean-up.

If the server is connected to the Internet you will get an Upgrade notification if there is a newer version of

the SimView software, the software is not automatically updated, but you can download from

www.laerdal.com/download and install it on the server.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48

No comments

Laerdal SimView User Manual Page 42