Laerdal VitalsBridge User Manual download pdf (Page 36)

VitalsBridge Directions for Use

rev. B.7 PN 10229

12. Input the SSID (i.e., the name of the network) and password that is set for you SimMan 3G’s

internal router. Click the “Submit” button.

13. The Network Configuration Tool will configure the VitalsBridge to connect to the SimMan3G

wirelessly. Configuration takes approximately 1 minute. Do not power off the VitalsBridge

during this process.

14. The process is complete when the Network Configuration Tool dialog box reads “Power Cycle

VitalsBridge before attempting to connect via Wi-Fi”.

15. Turn off VitalsBridge.

16. Close Network Configuration Tool.

Your VitalsBridge is now set up to connect wirelessly.

VitalsBridge Network Configuration Using an External LAN

Consult your network administrator for assistance configuring the VitalsBridge on an external LAN.

Using an Ethernet cable, connect the VitalsBridge to a LAN where the PC is located. Note: the local area

network must have UDP multicasting installed.

LAN Manual Connection

For a manual LAN, uncheck the “Use DHCP” box in the Network Configuration Tool window, and check

the “Assign Manually” box. You may then input the IP, Gateway, and Subnet manually. Note: a

manually assigned LAN ip address is not recommended.

1 2 ... 31 32 33 34 35 36 37 38 39

No comments

Laerdal VitalsBridge User Manual Page 36